Axis Q1910 Handleiding

Axis IP camera's Q1910

Lees hieronder de 📖 handleiding in het Nederlandse voor Axis Q1910 (102 pagina's) in de categorie IP camera's. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/102

Please read through this Installation Guide carefully before installing the product. Keep the

Installation Guide for further reference.

The AXIS Q1910/Q1910-E uses a 3.0V CR2032 Lithium battery as the power supply for its internal real-

time clock (RTC). Under normal conditions this battery will last for a minimum of 5 years. Low battery

power affects the operation of the RTC, causing it to reset at every power-up. A log message will appear

when the battery needs replacing. The battery should not be replaced unless required!

• If the battery does need replacing, please contact www.axis.com/techsup for assistance.

• Danger of Explosion if battery is incorrectly replaced

• Replace only with the same or equivalent battery, as recommended by the manufacturer.

• Dispose of used batteries according to the manufacturer's instructions.

• Do not use chemicals, caustic agents, or aerosol cleaners. Use a damp cloth for cleaning.

• Only use accessories and replacement parts provided or recommended by Axis.

• Do not attempt to repair the product by yourself, contact Axis or your Axis reseller for service matters.

!CAUTION! - When transporting the camera, use the original packaging or equivalent to

prevent damage to the product.

!CAUTION! - Avoid exposing the camera to vibration, shocks or heavy pressure and do

not install the camera on unstable brackets, unstable or vibrating surfaces or walls,

since this could cause damage to the product.

!CAUTION! - Only use handtools when installing the camera, the use of electrical tools

or excessive force could cause damage to the product.

!CAUTION! - Do not aim the camera lens toward the sun or other high-intensity

radiation sources since this could cause damage to the sensor.

!IMPORTANT! - To use AXIS Q1910 outdoors, it must be installed in an approved

outdoor housing. Please install AXIS Q1910-E for outdoor use or see www.axis.com for

more information on outdoor housing and other accessories.

!IMPORTANT! - The camera should be installed by a trained professional. Please observe

relevant national and local regulations for the installation.

!IMPORTANT! - Do not install the camera near heat sources since fluctuating

temperatures may affect image quality.

!IMPORTANT! - This product must be used in compliance with local laws and

regulations.

!IMPORTANT! - Store and transport the camera in a dry and ventilated environment.

Keep the storage and operating temperature between -40ºC and 50ºC

(-40ºF and122ºF).

Product specificaties

Merk:	Axis
Categorie:	IP camera's
Model:	Q1910
Gewicht:	990 g
Processormodel:	ARTPEC-3
Maximum resolutie:	720 x 576 Pixels
Type stroombron:	Power over Ethernet (PoE)
Video bewegings-detectie:	Ja
Aantal Ethernet LAN (RJ-45)-poorten:	1
Certificering:	EN 55022 Class B, EN 61000-3-2, EN 61000-3-3, EN 55024, EN 61000-6-1, EN 61000-6-2, EN 60950-1, FCC Part 15, Subpart B, Class B, VCCI, Class B ITE, C-tick AS/NZS CISPR 22, ICES-003, Class B, IP66
Ingebouwde microfoon:	Ja
Intern geheugen:	128 MB
Maximaal 30 frames per seconde:	8.33 fps
Ondersteunde netwerkprotocollen:	IPv4/v6, HTTP, HTTPS, QoS Layer 3 DiffServ, FTP, SMTP, Bonjour, UPnP, SNMPv1/v2c/v3(MIB-II), DNS, DynDNS, NTP, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS
Flash memory:	128 MB
Power over Ethernet (PoE):	Ja
Sample rate:	16 kHz
Afmetingen (B x D x H):	172 x 78 x 211 mm
Stroomverbruik (typisch):	8.2 W
Bedrijfstemperatuur (T-T):	-40 - 50 °C
Kijkhoek lens, horizontaal:	17 °
Actieve ombevoegde demontage alarm:	Ja
Audio detectie:	Ja