Avantone Pro GAUSS 7 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Avantone Pro GAUSS 7 (2 pagina's) in de categorie Monitor. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
GAUSS 7
www.avantonepro.com
Avantone Pro
Po Box 748
Tallman NY 10918
+1 845 642 3697
IMPORTANT SAFETY INSTRUCTIONS
Exposure to extremely high noise levels may cause permanent hear-
ing loss. Individuals vary considerable in susceptibility to noise-induced
hearing loss, but nearly everyone will lose some hearing if exposed to
sufficiently intense noise for a period of time. The U.S. Governments
Occupational Safety and Health Administration (OSHA) have specified the
permissible noise level exposures shown in the following chart.
According to OSHA, any exposure in excess of these permissible limits
could result in some hearing loss. To ensure against potentially danger-
ous exposure to high sound pressure levels, it is recommended that all
persons exposed to equipment capable of producing high sound pressure
levels use hearing protectors while the equipment is in operation. Ear
plugs or protectors in the ear canals or over the ears must be worn when
operating the equipment in order to prevent permanent hearing loss if ex-
posure is in excess of the limits set forth here.
Duration, per
day in hours
Sound Level dBA,
slow response
Typical example
8 90 Duo in small club
6 92
4 95 Subway train
3 97
2 100 Very loud classical music
1.5 102
1 105 That couple screaming
at each other
0.5 110
<0.25 115 Loudest parts at a rock concert
The Avantone Gauss 7 Monitors comply with all applicable / RoHS /
WEEE European Union directives.
Do not attempt to service this unit yourself, as it will void your war-
ranty. Please check your unit carefully upon receipt and return to place of
purchase immediately if there are any problems with the product. After
that, the standard AVANTONE 5 YEAR warranty will apply to defects in
materials and workmanship.
U.S.A.
Should your AVANTONE product require service, please contact the
AVANTONE PRO Service Department. +1 845 642 3697-or- e-mail info@
avantonepro.com. You must obtain an RA # (Return Authorization num-
ber) from us before shipping a unit back to us. This RA # must be clearly
written on the outside of the box.
Please safely pack the units…It is best to use the original packing mate-
rials. AVANTONE PRO cannot be responsible for any damages incurred
in shipping to us due to poor packaging. PLEASE PACK CAREFULLY and
FULLY INSURE THE SHIPMENT.
INTERNATIONAL
For service or warranty assistance, please contact the AVANTONE PRO
distributor in your country through the dealer from whom you purchased
this product.
LIMITED 5 YEAR WARRANTY
AVANTONE GAUSS 7s are warranted by Avantone Pro to be free from
defects in materials and workmanship for the period of 5 YEARS to the
original purchaser. In the event of such defects, the Avantone Pro product
will be repaired without charge or, at our option, replaced with a new one
if delivered to Avantone Pro prepaid, together with a copy of the sales slip
or other proof of purchase date. The warranty excludes problems due to
normal wear, abuse, shipping damage or failure to use the product in ac-
cordance with the specifications.
All speaker systems are vulnerable to damage from sustained amplifier
clipping. This can be described as a distortion of the signal caused by the
amplifier running out of headroom. Heat will then be generated in the
voice coil of the driver beyond the heat handling capabilities of wire and
glue. At some point the voice coil will burn, causing the speaker to sound
very distorted; eventually the driver will stop working.
All parts and labor are covered under this Limited Warranty. However, if it
is determined by AVANTONE PRO that the voice coil was burned due to
sustained amplifier clipping, we reserve the right to charge the customer
for the cost of the repair, since this is considered abuse.
Avantone Pro shall not be liable for damages based upon inconvenience,
loss of use of the product, loss of time, interrupted operation or com-
mercial loss or any other damages, whether incidental, consequential, or
otherwise. This warranty gives you specific legal rights, and you may have
other rights, which will vary from state to state.
This warranty is not transferable.
INTRODUCTION
Classics never die Avantone is proud to bring Gauss back to the world
with the Gauss 7 reference monitor.
Decades after the disappearance of the Gauss Speaker Company, the line
has returned with a proper (low-end) bang. Gauss 7 mixes the old-school
snap of vintage near-field monitors, with the bandwidth and frequency
response of new-school monitors.
We at Avantone can’t wait for you to hear the Gauss 7, and were certain
you’ll be blown away.
REAR PANEL CONNECTIONS
1. Balanced XLR Input: This input accepts a BALANCED male XLR plug.
2. Balanced TRS Input: This input accepts a balanced TRS ¼” male plug.
3. Gain: This variable control adjusts the sensitivity of the signal that ap-
pears at the input.
NOTE: When the signal appearing at the input is too hot,
the amplifier can overload causing distortion and possible
damage to the speaker. If overload occurs, decrease the in-
put level by turning the knob counter-clockwise a few clicks.
4. Acoustic Placement: This switch cuts bass frequencies down by either
-4dB or -2dB to correct for boundry bass issues when the monitor has
been placed near a wall or corner.
-4dB - In corner: If your monitors are setup in the corner of a
room, then make sure you are on this setting.
-2dB - Close to wall: If your speakers are between 2-4 feet
from a wall, then make sure you are on this setting.
0dB - Middle of room: If your monitors are setup almost
perfectly in the middle of a room (or well beyond any walls if
in a large space), then make sure you are on this setting.
5. High Trim: This switch cuts or boosts high frequencies by ± 2dB.
6. Power Switch: This switch engages power for the unit.
7. AC Input: The AC inlet accepts standard IEC320 C14 cables. The inte-
grated fuse tray should have the correct fuse value installed as indicated
on the rear panel for the AC voltage being applied.
QUICK START GUIDE
ö Connect the output of your source to the input of the Gauss 7.
ö Turn Gain down all the way.
ö While playing audio from the source, adjust the Gain on each Gauss
7 accordingly.
NOTE: Using a decibel meter (or an app on your mobile de-
vice) can help with calibration between each Gauss 7, or
multiple sets of monitors!
ö System Type: Active Full-Range Two-Way Stereo Pair
ö Frequency Response: 30Hz-22,000Hz
ö Cabinet: Bass Reflex design, hybrid medium-den-
sity fiberboard with real wood veneer
ö LF Driver: 7 (178mm) Ferrite Motor GAU-7MLF
ö HF Driver: 2.5 (65mm) GAU-AMT
ö LF Amplifier Power: 120 W
ö HF Amplifier Power: 60 W
ö Amplifier Type: Bi-Amped Class D
ö SPL: 103dB (Peak)
ö THD: 0.5%
ö Controls: Gain (variable) / Acoustic Placement
(-4dB, -2dB, 0db) / High Trim (-2dB, 0dB,
+2dB)
ö Inputs: Balanced TRS / XLR
ö Power: 110V-240V ~50/60Hz
ö Power Consumption: StandBy: <0.5 W / Full Output: 250 W
ö Dimensions: 381mm H x 235mm W x 212mm D
ö Weight: (15” H x 9.25 W x 8.35 D)
8.2Kg / 18 Lbs (Each)
SPECIFICATIONS
1
7
2
6
345


Product specificaties

Merk: Avantone Pro
Categorie: Monitor
Model: GAUSS 7

Heb je hulp nodig?

Als je hulp nodig hebt met Avantone Pro GAUSS 7 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Monitor Avantone Pro

Handleiding Monitor

Nieuwste handleidingen voor Monitor