Aurum 770 Handleiding

Aurum Luidspreker 770

Lees hieronder de 📖 handleiding in het Nederlandse voor Aurum 770 (23 pagina's) in de categorie Luidspreker. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/23
ESPAÑOL
FRANÇAIS
ENGLISH
DEUTSCH
USER INSTRUCTIONS
BEDIENUNGSANLEITUNG
NOTICE D´UTILISATION
MANUAL DE INSTRUCCIONES
BDA AURUM 22.1005.indd 1 30.10.2005 15:39:02 Uhr
2
3
Contents/Inhalt/Sommaire/Índice
Safety notes 3-4
Setting up 5-6
Stands and wall mounts 6
Connecting up your amplifier 6-9
Beware of clipping 9
Tips for better acoustics 10
Care of loudspeakers 11
What to do if your speakers don‘t sound right ? 12
Sicherheitshinweise 13-14
Aufstellung 15-16
Stative und Wandhalterungen 16
Anschluss an den Verstärker 16-19
Vorsicht Clipping 19
Tipps fĂźr eine bessere Akustik 20
Pflege der Lautsprecher 21
Was tun in StÜrungsfällen ? 22
SĂŠcuritĂŠ 23-24
Installation 25-26
Pieds et supports muraux 26
Raccordement 26-29
Attention au ÂŤclippingÂť 30
Conseils pour une meilleure acoustique 30
Nettoyage des haut-parleurs 31
Que faire en cas d’anomalies ? 32
Seguridad 33-34
DisposiciĂłn 35-36
Soportes de pie y de pared 36
ConexiĂłn al amplificador 36-39
Cuidado con el Clipping 39
Consejos para una mejor acĂşstica 40
El mantenimiento de las cajas acĂşsticas 41
ÂżQuĂŠ hacer en caso de averĂ­a? 42
First of all, thank you for deciding on AURUM loudspeakers.
It is to satisfy the high expectations of music lovers and connoisseurs such as you that
we build loudspeakers of a class that is well above average. Even though you may
already be familiar with them, we list below a few ground rules that will enable you
to make optimal use of your loudspeakers.
Safety advice for passive loudspeakers
Please take time to read through the manual carefully and follow all the steps
describing how to set up and operate the loudspeakers. Keep the manual
somewhere you can quickly access it should you have any questions later on.
• The stability of loudspeakers (especially large units) depends on the nature of
the surface on which they stand. Carpets are often very poor for stability. Even an
average bump can cause a loudspeaker to fall over and be a hazard for persons
or pets in the vicinity. Stability can be significantly improved by using “spikes”, but
care should be taken during assembly as the sharp points can cause injury and
the spikes can damage the floor. On smooth floors, the loudspeakers can be
stabilised with Velcro or double-sided tape. Loudspeakers should never be used
as a seat or as a substitute for a ladder!
• Use only wheeled furniture, stands or wall mounting systems and other devices for
attaching and installing the products, which are available from the manufacturer
and are sold for or with the product. To avoid damage or injury through tipping
over, please be careful when moving table devices or stands on which the
speakers are mounted. If wall-mounting the product, take special care that all
components are securely screwed! Additional securing equipment (chains, etc.)
should be fitted.
• The location for the loudspeakers should be dry and not too cold. Constant high
humidity or strong sunlight (UV radiation) can cause your loudspeakers to age
prematurely and consequently affect their functioning.
• Very high volume levels for long periods of time are not only annoying for your
neighbours, but can also be harmful to the health of the user!
• When loudspeakers are overloaded with very high volume levels, there is a risk
of individual components in crossover circuits or individual speakers burning out.
In particularly bad cases, it is even possible for fire to break out inside a speaker.
Speakers operated at these extremes should therefore not be left unattended.
• At high volumes, voltage levels of 30–50 V can be present at speaker terminals
and components. Be very careful not to touch uninsulated terminal contacts of
speakers when in operation. To avoid injury, never put hands or arms into sound
outlets (bass reflex tubes). Children and pets, in particular, are at risk from this.
ENGLISH
FRANÇAIS
ESPAÑOL
DEUTSCH
BDA AURUM 22.1005.indd 2-3 30.10.2005 15:39:03 Uhr
4
5
Setting up
To obtain optimal sound results, it is generally necessary to try out different set-ups.
Since the room conditions have a major effect on sound reproduction, we suggest
below a few useful approaches for positioning your AURUM loudspeakers.
Main speakers (front)
Where the speakers are positioned in the listening space has a decisive effect on
their sound. Placing the speakers near the corners of the room will essentially give
you loud bass reproduction but with little outline. On the other hand, speakers
positioned well away from the walls sound precise, but also very bright and thin. The
best solution is to place the speakers with at least 30 cm between their backs and
the nearest wall. To avoid loud wall reflections, the distance from the side walls of the
room can even be 50 cm or more. Bookshelf speaker units sound best on a speaker
stand or shelf, with the tweeters arranged at ear height. The cases should be angled
and slightly tilted to achieve this.
Ss far as possible, the speakers should be equidistant from the listening position, while
the distance of the speakers from each other can be rather less than the distance
from the listener.
Front centre speaker
The centre loudspeaker is magnetically
shielded, therefore causes neither colour
faults nor distortion in the TV picture and
should if possible be placed directly on
the TV. If this is not possible, place the
centre speaker horizontally beneath
the TV, with the distance to the floor
being at least 20 cm.
Apart from the above, we recommend
angling the centre speaker so that the
tweeter is aimed at the listener in order
to enjoy its full sound potential.
• For safety reasons, we generally forbid the opening of loudspeaker cabinets
when in operation or connected since, as explained in the above paragraph,
voltages of up to 50 volts can be present inside.
• Improper handling of mains voltage can cause fatal injury!
Passive loudspeakers must on no account be connected to the electricity
supply!
Speaker terminals may only be connected to the appropriate output terminals
of the amplifier. You should never connect these terminals to the electricity supply
(230 V/115 V) in any way since that will otherwise also immediately destroy the
loudspeaker and all connected products. Avoid fitting plugs to ends of speaker
cables that could even remotely be confused with mains supply plugs.
• Loudspeakers that are not magnetically shielded can affect the colour of the
TV picture or cause distortion. A distance of 50 cm is generally sufficient to avoid
problems of this kind. Avoid placing items such as credit cards, diskettes, audio or
video cassettes or other magnetic media on the loudspeaker. This could destroy
the information stored on them. Similarly, avoid operating magnetic tape devices
in the immediate vicinity.
CENTER
FRONT
TV
FRONT
SUBWOOFER
REAR
REAR
50 cm
>
–
REAR
CENTER
BDA AURUM 22.1005.indd 4-5 30.10.2005 15:39:05 Uhr

Product specificaties

Merk: Aurum
Categorie: Luidspreker
Model: 770

Heb je hulp nodig?

Als je hulp nodig hebt met Aurum 770 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Luidspreker Aurum

Aurum

Aurum 970 Handleiding

3 Mei 2023
Aurum

Aurum TITAN VII Handleiding

3 Mei 2023
Aurum

Aurum 770 Handleiding

3 Mei 2023

Handleiding Luidspreker

Nieuwste handleidingen voor Luidspreker

JBL

JBL 4367 Handleiding

25 Oktober 2023
Tannoy

Tannoy turnberry he Handleiding

15 Oktober 2023
Omnitronic

Omnitronic PAS-212 Handleiding

9 Oktober 2023
KEF

KEF C1 Handleiding

8 Oktober 2023
KEF

KEF KIT 160 Handleiding

8 Oktober 2023
KEF

KEF PSW2150 Handleiding

8 Oktober 2023
KEF

KEF KIT 530 Handleiding

8 Oktober 2023
KEF

KEF KIT 550 Handleiding

8 Oktober 2023
KEF

KEF Ventura 6 Handleiding

8 Oktober 2023
KEF

KEF Reference 206-2 Handleiding

8 Oktober 2023