Audac WS524 Handleiding

Audac Speaker WS524

Lees hieronder de 📖 handleiding in het Nederlandse voor Audac WS524 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

PROFESSIONAL AUDIO EQUIPMENT

In-Wall Speaker WS524

Installation Guide

In-

all

Speaker

WS524

AUDAC

Installation Procedure

1) Cut a hole in the ceiling or wall on the desired mounting location of the loudspeaker. This should be a

square with the following dimensions: 147mm x 147mm. The included cutout template can be used

for marking.

2) Provide the loudspeaker connection cable through the mounting hole.

3) Take the loudspeaker, and remove the front grill.

The front grill can be removed by rotating the mounting clips outwards and pushing them down. The

fixing screws will push the front grill out.

4) Pull the mounting clips up again, and rotate them inwards, making the speaker fit through the

mounting hole in the ceiling.

5) Connect the loudspeaker connection cable with the power tap connection block. On this connection

block, several connections can be made for different power taps. Depending of the desired power,

connections can be made for 8 Ohm Low impedance application, or 24 Watt / 12 Watt / 6 Watt for

100 Volt applications.

Press the locking mechanism of the desired power tap down, and insert the connection cable. After

releasing the locking mechanism, the speaker connection cable is connected to the loudspeaker or

transformer.

Always connect the common of the amplifier output to the C terminal, and the positive amplifier

output to the desired terminal. (8 Ω For low impedance applications and the desired power terminal for

100 Volt applications).

6) Once the connections are made, the loudspeaker can be installed in the provided mounting hole. Insert

the speaker in the provided mounting hole, and use a screwdriver for tightening the fixing screws.

Once the screws are tightened by a quarter turn, the mounting clip will rotate outwards and will be

locked behind the ceiling. From this moment, the loudspeaker cannot fall out the ceiling. To make the

speaker equal with the ceiling, the fixing screws should be tightened.

7) Once the mounting screws are tightened, the front grill can be assembled to the loudspeaker.

On locations where high vibrations may occur, it is recommended to push the included small rubber

pieces into the groove where the grill fits in. This small rubber pieces makes sure that the grill won’t

come out by vibrations.

Product specificaties

Merk:	Audac
Categorie:	Speaker
Model:	WS524
Kleur van het product:	Wit
Gewicht:	1190 g
Breedte:	180 mm
Diepte:	90 mm
Hoogte:	180 mm
Materiaal behuizing:	Acrylonitrielbutadieenstyreen (ABS)
Connectiviteitstechnologie:	Bedraad
Gemiddeld vermogen:	30 W
Aanbevolen gebruik:	Universeel
Impedantie:	8 Ohm
Audio-uitgangskanalen:	1.0 kanalen
Speaker plaatsing:	Inbouw in de muur/plafond
Aantal drivers:	2
Woofer:	Ja
Frequentiebereik:	60 - 20000 Hz
Gevoeligheid:	92 dB
Versterkeraansluiting (binding post):	Ja
Maximaal vermogen:	60 W
Luidspreker soort:	2-weg
Diameter woofer:	5.25 "
Diameter hogetonenluidspreker:	1 "
Tweeter:	Ja
AirPlay:	Nee
Multi-Room Streaming (MRS)-ondersteuning:	Nee