Ashdown Engineering HOD-600 Handleiding
Ashdown Engineering
Receiver
HOD-600
Bekijk gratis de handleiding van Ashdown Engineering HOD-600 (7 pagina’s), behorend tot de categorie Receiver. Deze gids werd als nuttig beoordeeld door 63 mensen en kreeg gemiddeld 4.9 sterren uit 32 reviews. Heb je een vraag over Ashdown Engineering HOD-600 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/7
INPUT - There is a single instrument input provided linked to
a PASSIVE/ACTIVE selector switch. The Passive input (switch
out) is high sensitivity and also high impedance to suit the
output from PASSIVE basses. The Active input (switch in) is
low sensitivity and lower impedance to suit the output from
ACTIVE basses.
INPUT CONTROL - The INPUT control sets the signal level
through the preamp in conjunction with the INPUT LEVEL VU
Meter. This is adjusted to give a reading of 0VU on the meter
for average playing dynamics with occasional peaks into the
red region. Please note that the setting of this may have to be
re-adjusted after modication of the EQ controls.
PUSH FLAT / SHAPE - With this button in its OUT position a
xed E.Q. is superimposed on the preamp to give a bright but
punchy character to the sound. Pushing this button IN returns
the preamp to a Flat frequency response. This function may
also be controlled from a footswitch. For the footswitch to
operate this button must be in its OUT position.
DOOM - This routes the signal either through a clean Solid
State amplication section (control on zero) or through a
Dual Triode Tube amplication/overdrive section in order
to add either tonal character i.e. warmth with the control
set at 9 o’clock, a slight edge in the sound at 12 0’clock
through to an increasing degree of Tube distortion/over-
drive as the control is advanced to maximum.
A Mix of these two amplication sections can be achieved
with this control.
N.B. The degree of tube distortion provided by this control
will also depend on the setting of the INPUT control.
DOOM IN/OUT - This push button switches the valve drive
section IN or OUT. This function may also be controlled from
the Ashdown 4 way footswitch. For the footswitch to operate
this button must be in its OUT position.
E.Q. IN / OUT - This push button switches the Equalisation
section IN or OUT i.e. the Bass, Middle and Treble controls
plus the two sets of sliders placed between each of these.
WWW.ASHDOWNMUSIC.COM
HEAD OF DOOM USER GUIDE:
Product specificaties
| Merk: | Ashdown Engineering |
| Categorie: | Receiver |
| Model: | HOD-600 |
Heb je hulp nodig?
Als je hulp nodig hebt met Ashdown Engineering HOD-600 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Receiver Ashdown Engineering
3 Juli 2023
6 Juni 2023
26 Mei 2023
24 Mei 2023
24 Mei 2023
22 Mei 2023
Handleiding Receiver
- Audiofrog
- Mtx Audio
- Deaf Bonce
- Chord
- JB Systems
- Douk Audio
- Dimavery
- MIPRO
- Panduit
- HQ
- PureLink
- Smart-AVI
- HEOS
- Astell&Kern
- Ashly
Nieuwste handleidingen voor Receiver
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025