APPS2Car M02-T2 Handleiding

Bekijk gratis de handleiding van APPS2Car M02-T2 (1 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 8 mensen en kreeg gemiddeld 4.5 sterren uit 4 reviews. Heb je een vraag over APPS2Car M02-T2 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

INSTALLATION GUIDE

Step 1

- 1 -- 2 -

- 3 -- 4 -

Unscrew the fixed nut completely. Let the ball joint pass

through the fixed nut (the thread must face to the groove).

Step 3

Cl th dashboard wth dloth.eaneiry c

Step 5

Let it sit for at least 24 hours before using to achieve

the strongest adhesion.

Step 4

Put the magnetic mount on the dash and firmly press

it. Hold in place for about 30 seconds.

Step 6

Once the mount is secured in place, remove the protective

film and set the Metal Plate.

You may place the metal plate as following shows.

Installation between the case and device

Removal Paper

Metal Plate

Scratch Protective Film

Opition 1

Installation on the back of device

Opition 2

Installation on the back of the case

Opition 3

12

Step 2

Push the ball joint firmly into the groove on the back of the car

mount, then tighten the fixed nut.

Magnetic Car Mount

On The Dashboard

MT01

YOUR BEST DRIVE PARTNER

User Manual

Dear Customer

please do not hesitate to

contact us at anytime

If you have anstiy queon

we are always here if you need!

ATTENTION!!

- 5 -

- 6 -

Use a thin plastic card

to carefully lift the

dashboard pad from

the mounting surface.

Slowly lift up and

remove it.（Remember

not too hard and

move it slowly）

Tips 2

Remove Dashboard Disk Pad

Tips 1

Viscosity of VHB Sticky Tape

Time of Viscosity

①Cleaning the flat surfaces to ensure that there is no

dust or oil.

②Do not leave fingerprints on the 3M sticky tape.

③When applying, please make sure that the

temperature of the flat surface and the sticky gel

should be above 68℉, or you may soften the 3M VHB

tape under heating air before installation.

④Press for 8 to10 seconds after pasting.

⑤ Recommended to use after of pasting. 24 hours

⑥Never uses the adhesion promoter on the metal

surface.

For better pasting, please kindly note:

3M

Product specificaties