Apc SURTA48XLBPJ Handleiding

Apc Accu SURTA48XLBPJ

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc SURTA48XLBPJ (12 pagina's) in de categorie Accu. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12

APC Smart-UPS®

RT SURTA48XLBP/SURTA48XLBPJ

External Battery Pack User Manual

Introduction/Before Installation

About this Manual

The APC Smart-UPS® RT external battery pack (SURTA48XLBP or SURTA48XLBPJ) connects to

the APC Smart-UPS RT uninterruptible power supply (SURTA1500XL and SURTA2000XL, or

SURTA1500XLJ). Together these units provide extended protection against blackouts, brownouts,

sags and surges reaching your computers, servers, and other sensitive electronic equipment.

Illustrations are representative. Your configuration, including components and optional APC equip-

ment, may be different from the models shown in this manual. The user manual is accessible from the

supplied CD and the APC Web site, www.apc.com.

Contact Information

Refer to www.apc.com to contact APC or for additional information about this product.

Safety Information

Unpacking and Equipment Placement

1. Unpack the equipment. The packaging is recyclable; save it for reuse or dispose of it properly.

2. Inspect the equipment upon receipt. Notify the carrier and dealer if there is damage.

3. Check the package contents:

– the battery pack and front bezel

– a literature kit containing user manual, two clips, two stabilizing foot extensions with

hardware, product documentation, warranty documentation, and safety information.

Warnin g

Read the Safety Guide before you begin the installation, operate the battery pack,

or perform equipment maintenance. Failure to comply with safety instructions

could result in bodily injury or equipment damage.

To lighten the load, remove battery modules before installing equipment, or when

transporting the equipment to another location.

Heavy

The equipment is heavy. Two people are required to lift the UPS or battery pack.

Select a location sturdy enough to handle the weight of the equipment.

Note

The battery pack is shipped with the battery modules installed. Battery modules are

shipped DISCONNECTED to be in compliance with U.S. Department of

Transportation (DOT) regulations.

Pre-installation Procedure

2 Smart-UPS RT SURTA48XLBP/SURTA48XLBPJ External Battery Pack User Manual

4. Place the battery pack where it will be used.

– Ensure that air vents on the front and rear of the unit are not blocked.

– Do not operate the battery pack where there is excessive dust or the temperature or humidity

are outside the specified limits.

Pre-installation Procedure

1. Once the battery pack is at the installation site, remove the top cover  and battery modules 

to lighten the load and prepare the battery pack to be installed in a tower or rack-mount

configuration.

2. To disengage the battery from the chassis, push the battery tabs  inward.

3. Go to the installation procedures to install the UPS and battery pack as a tower  (page 3) or in a

rack-mount  (page 5) configuration.

2.5

40°C

104°F

95%





 

Tower Installation

Smart-UPS RT SURTA48XLBP/SURTA48XLBPJ External Battery Pack User Manual 3

Tower Installation

1. Complete this step if this is a new installation of the UPS with battery pack(s).

a. Place the UPS on its side to remove the battery. To remove the battery, refer to the “Battery

Replacement Instructions” procedure in the UPS user manual.

b. Remove the stabilizing feet  and top cover . Retain removed components for reuse.

c. Join the equipment together as shown.

• Assemble the stabilizing feet  and foot extensions .

• Place the UPS  on top of the battery pack.

• Attach the stabilizing feet , clips , and top covers .

d. Place the equipment in an upright position.

Caution

When installing the UPS and battery pack(s) as a tower configuration, they must

be joined together with stabilizing feet and clips. Failure to comply to this

instruction may result in bodily injury or equipment damage.

Note

When installing the UPS and battery pack(s) as a tower configuration, battery pack(s)

must be installed to the right of the UPS when facing the front of the UPS. Failure to

follow this instruction could result in cabling shortage.











Product specificaties

Merk:	Apc
Categorie:	Accu
Model:	SURTA48XLBPJ
Kleur van het product:	Zwart
Gewicht:	32000 g
Breedte:	432 mm
Diepte:	565 mm
Hoogte:	86 mm
Gewicht verpakking:	39000 g
Breedte verpakking:	595 mm
Diepte verpakking:	753 mm
Hoogte verpakking:	275 mm
Accu/Batterij voltage:	48 V
Certificering:	CSA
Batterij capaciteit:	864 VAh
Temperatuur bij opslag:	-20 - 50 °C
Luchtvochtigheid bij opslag:	0 - 95 procent
Hoogte, in bedrijf:	0 - 3000 m
Hoogte bij opslag:	0 - 15000 m
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 95 procent
Batterijtechnologie:	Sealed Lead Acid (VRLA)
Code geharmoniseerd systeem (HS):	85044090