Apc RBC23 Handleiding

Bekijk gratis de handleiding van Apc RBC23 (1 pagina’s), behorend tot de categorie Accu. Deze gids werd als nuttig beoordeeld door 49 mensen en kreeg gemiddeld 4.8 sterren uit 6 reviews. Heb je een vraag over Apc RBC23 of wil je andere gebruikers van dit product iets vragen? Stel een vraag



















SURM2U Replacement Battery Cartridge installation Guide

This UPS has an easy to replace hot-swappable battery tray. Battery replacement is a safe

procedure, isolated from electrical hazards. You may leave the UPS and the protected equipment

onr tllngprocede. See r dealer or fohe foowi uryou www.apcc.com for more information.

Smart-UPS ModelReplacement Battery Cartridge

SU700M2UR RB22C

SU1000RM2U RBC23

SU1400RM2U RBC24

Pleae sread boepcg etey yefr relainth batrtra:

Once te btery is connced, e cnneeqpent isprefom powerhat disetthocted uim not otcted r otages.u

Battery Replacement Procedure

1.The battery tray is accessible from the front of the UPS.

2.Be careful removing the battery tray – it is heavy.

3.This procedure requires a Phillips head screwdriver.

4.Small sparks at the battery connectors are normal during re-connection.

SU1400M 2URJ J RB 24C

1.Face the front of the UPS and, using both hands, insert each

index finger behind the lip of the curved section of the front

pael bezel ad pll tards. e ot pal bezellnnuow youThfrnne wil

u sn.nap

2.Set te bezel aide.hs

3.Take out the white cord, which is tucked into the space above

the battery connector . Grasp the cord and pull firmly

towards you to disconnect the battery.

4.Use a Phillips head screwdriver to remove the four (4)

screws  that secure the battery tray. Set the screws aside.

5.Use the battery tray handle  to slide the tray out halfway.

Then hold the tray from the sides and slide it out to the

maximum extended position. A stop tab  on the bottom of

te tryll eet e trym cgt clete.ha wiprvntha fro omin ouomply

6.Carefly lt te tryp soat tstptabul if ha u thhe o  clearste h

ledge on the unit.

7.Return the battery tray to APC using the package in which

younr repaclemetry spped . ta hi

Thue attery reactit clb pleemn kindes a new battery tray.

8.Hold the new tray on the sides and align it with the opening.

9.Raise the back of the tray up slightly to position the stop tab

on the inside of the opening. Then level the tray and push it

in completely.

10.Remove the tape on the new battery tray connector to expose

the cable connector.

11. Locate the UPS battery connector  which is to the right of

the battery tray and recessed. Connect the battery cable

connector to the UPS connector. Press firmly to ensure that

the connection is tight. You will hear a “snap” when the

connector is properly seated.

12.Replace the four (4) screws removed in step 4.

13.Tuck the white battery cable cord neatly into the space above

the UPS connector.

14.Hold the front panel bezel with the cutout section on the

right. Align the tabs on the side of the bezel with the slots on

the front of the UPS  and firmly snap it into place.





990-#### Rev.01 11/01

Product specificaties