Apc APDU1303 Handleiding

Bekijk gratis de handleiding van Apc APDU1303 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 14 mensen en kreeg gemiddeld 4.0 sterren uit 6 reviews. Heb je een vraag over Apc APDU1303 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

990-91599

4/2022

© 2022 Schneider Electric. All rights reserved.

Worldwide Customer Support

Customer support and warranty information is available at

www.apc.com

NetShelter Rack PDU Advanced

Door Sensor Kit APDU1303

Installation

IMPORTANT INFORMATION

The Door Switch Sensor is designed to send an alarm or notification signal when the door

on which it is installed is opened more than 10mm.

The installation location of the Magnet and Magnetic Switch for the Door Switch Sensor

is dependent on the configuration of your rack and your specific requirements.

NOTE:Use the RJ45 coupler (provided) and an additional 1.8 m RS-485 extension cable

(provided) to extend the length of the RS–485 cable attached to the door sensor. You can

use a longer RS–485 cable (not provided) to extend the length up to 30.5 m (100 ft).

NOTICE

HAZARD OF EQUIPMENT DAMAGE

This Door Switch Sensor is designed to connect only to a NetShelter Rack PDU

Advanced. Connecting the sensor to another device may result in damage.

Failure to follow these instructions can result in equipment damage.

NOTICE

• The Magnet and the Magnetic Switch do not require physical contact to operate

properly.

• For each installation option, test that the Door Switch Sensor is operational while

holding the Magnet in its intended position before securing the Magnet.

Inventory

Door Switch Sensor Assembly (Qty 1)

RJ45 Connector (Part of Door Switch Sensor Assembly)

RS–485 Cable (Part of Door Switch Sensor Assembly)

Door Switch Sensor (Part of Door Switch Sensor Assembly)

Sensor Cable (Part of Door Switch Sensor Assembly)

Magnetic Switch (Part of Door Switch Sensor Assembly)

Magnet (Part of Door Switch Sensor Assembly)

Tap Screw (Qty 4)

Cable Tie (Qty 5)

Adhesive-Backed Mount (Qty 5)

RJ45 Quick Disconnect Coupler (Qty 1)

Double-Sided Adhesive Mounting Tape (Qty 2)

RS–485 Extension Cable 1.8m (Qty 1)

Tools Required (not provided)

Depending on your installation, the tools below may be required.

Drill with 1/16 in. (1.5 mm) bit #2 Phillips screwdriver

Product specificaties