Apart CM6QFT Handleiding

Apart Speaker CM6QFT

Lees hieronder de 📖 handleiding in het Nederlandse voor Apart CM6QFT (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 17 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

INFO@APART-AUDIO.COM

The new contractor’s reference

WWW.APART-AUDIO.COM

The APart CM6QFT, the new contractor’s reference: reduces the install labour drastically.

The APart CM6QFT 2-way built-in ceiling loudspeaker can be used as a 16 Ohm or 100 Volt

loudspeaker. In 16 Ohm use, you can connect up to 4 loudspeakers in parallel on each channel

of a standard 4 Ohm amplier. For 100 V use, the CM6QFT is equipped with a high-quality 6 Watt

100 Volt transformer with several power tappings. The loudspeaker has a 6 ½” paper cone woofer

what results in a very low distortion. To complete the sound a 1” tweeter has been integrated.

It makes the CM6QFT very suitable for the distribution of microphone calls and back ground

music. The housing is made of high quality ABS. The grille is made of steel. The standard colour

is white.

100V/1.5W : Black (common) – yellow

100V/3W: Black (common) – red

100W/6W: Black (common) – brown

16 ohm: rst disconnect the red and black wire between transformer and speaker. Connect the

speaker line to the free wire end on the speaker. Black = common, red = signal.

Patented Quick Fit system breaks all speed records

No screws : x and nish with 4 clicks only

Self adjusting clamp strength

Allowed board tickness : 12.5 to 29 mm

Discrete and stylish

Ultra thin plastic edge

Smooth at design

Strong metal grill

INFO@APART-AUDIO.COM

The loudspeaker is easy to install, due to its simple, quick mounting system.

Remove the grill before mounting, use the special grille removal tool and carefully

take out the grille.

Make sure the mounting clamps are turned inwards, if this is not the

case, insert the hex key in all four holes on the front and turn it

180 degrees counterclockwise until you hear a click. Insert the speaker

in the ceiling and activate the automatic clamp system. Use the supplied

hex key, but this time you insert the round side in the four holes on

the front. Push the key to release the 4 clamps. Carefully push

the grille back in place. That’s it.

Use this round side to push

the key to release the 4 clamps.

Use this hex side to load the

spring of the clamps.

Position the speaker in the ceiling.

Activate the spring clamps by pushing the four

spring clamp buttons with the round end of

the tool.

Turn the spring clamps 180º counter-

clockwise until you hear a click.

Take out the speaker.

Product specificaties

Merk:	Apart
Categorie:	Speaker
Model:	CM6QFT
Kleur van het product:	Wit
Gewicht:	1100 g
Soort:	Inbouwluidsprekers
Impedantie:	16 Ohm
Audio-uitgangskanalen:	2.0 kanalen
Peak Music Power Output (PMPO):	60 W
Frequentiebereik:	60 - 20000 Hz
Afmetingen (B x D x H):	237 x 65 x 237 mm
Diameter woofer:	165.1 mm
Diameter hogetonenluidspreker:	25.4 mm