AEG BE500452DM Handleiding

Bekijk gratis de handleiding van AEG BE500452DM (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.4 sterren uit 5 reviews. Heb je een vraag over AEG BE500452DM of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Installation Instruction

Warning! Beforeproeeding c with inallaionreastt, d

the safety inormaftioninhe t Us erManual.

The oven is designed to be connected to 230 - 240V

~ (50Hz) electricity supply.

The oven has an easily accessible terminal block which

is marked as follows:

Letter L - Live terminal

Letter N - Neutral terminal

- Earth terminal

CAUTION!

This oven must be earthed!

The cable used to connect the oven to the electrical

For UK use only

Connection

via

Min. size

type

Fuse

Cooker

Control

Circuit

2,5 mm²PVC / PVC

twin and

earth

min: 15 A

max: 20 A

It is necessary that you install a double pole switch

between the oven and the electricity supply (mains),

with a minimum gap of 3 mm between the switch

contacts and of a type suitable for the required load in

compliance with the current regulations.

The switch must not break the yellow and green earth

cable at any point.

EN

After installation and connecting, the cable must

be placed so that it cannot at any point reach

a temperature of more than 50°C above the

ambient temperature.

Before the oven is connected, check that the

main fuse and the domestic installation can

support the load; and that the power supply is

properly earthed.

The manufacturer declines any responsibility

should these safety measures not be carried out.

Attention: The new appliance may only be installed and

connected by a registered expert.

Please comply with this. If you do not, any

damage resulting is not covered by the warranty.

Safety information for the installer

The electrical installation is to be set up so •

that the appliance can be isolated from the

mains with a minimum 3 mm all-pole contact

separation.

Suitable separation devices include e.g. •

cut-outs, fuses (screw fuses are to be taken

out of the holder), RCD’s and contactors.

Anti-shock protection must be provided by the •

installation.

The built-in unit must meet the stability •

requirements of DIN 68930.

Built-in ovens and built-in cooking surfaces •

safety reasons, they must only be combined

with appliances from the same manufacturer.

Product specificaties