Advanced Network Devices ZONEC Handleiding
Pagina's 4 Staafmixer
Bekijk de handleiding van Advanced Network Devices ZONEC gratis online of download de PDF. Deze handleiding is 4 keer bekeken. Vraag over dit model? Stel een vraag
Zone Controller Installation
(ZONEC2)
Advanced Network Devices 3820 Ventura Dr. Arlington Hts. IL 60004 •
Support: te[email protected]mwww.anetd.com/user-support/ -- •8474632237 •
1v3 3.
OVERVIEW
The ZONEC2 Zone Controller provides
access to the following signals:
•2 General Purpose Inputs
•1 General Purpose Output Relay
(N.O. or N.C; optional 12VDC, 1A
max)
•Line-level Audio Input and Output
•8-ohm Speaker Output
•Microphone Input
DEVICE REQUIREMENTS AND
RESTRICTIONS
•PoE+ power source recommended for
AND-STROBE-KIT-1.
•Output relay functionally tested to
operate with the System Sensor Strobe
(AND-STROBE-KIT-1). The purchaser
should test any other peripheral before
deployment.
INSTALLATION
The device can mount on a wall using the
four keyhole features located at the
corners of the device and wall anchors
appropriate to the installation surface.
Power the device with PoE or PoE+,
connected via an Ethernet cable to the
PoE/PoE+ input. With power applied, the
green Power LED will illuminate.
If configured for switched 12VDC
(Output Mode is “Sw DC”), please make
sure not to leave the output in a manner
that could result in 12VDC shorted to
ground.
SETUP AND USE
Use stranded or solid core wire to
connect to the terminal blocks. See
pages 3 and 4 for details on setting up an
interface to an amplifier for traditional
analog speakers.
Product specificaties
| Merk: | Advanced Network Devices |
| Categorie: | Staafmixer |
| Model: | ZONEC |
Heb je hulp nodig?
Als je hulp nodig hebt met Advanced Network Devices ZONEC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Alle Advanced Network Devices Staafmixer handleidingen