ACDelco 10335583 Handleiding

Bekijk gratis de handleiding van ACDelco 10335583 (1 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 25 mensen en kreeg gemiddeld 4.4 sterren uit 2 reviews. Heb je een vraag over ACDelco 10335583 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

INSTRUCTION SHEET

KEY FOB PROGRAMMING INSTRUCTIONS -

10335583

FOR AUTOMOBILES:

These vehicles can be programmed using the

instructions below:

• 2001-2005 Chevrolet Venture

• 2001-2004 Oldsmobile Silhouette

• 2001-2005 Pontiac Montana

These vehicles require the use of a professional scan

tool for programming (see your local GM dealer or

ACDelco Professional Service Center):

• 2004-2012 Chevrolet Colorado

• 2004-2012 GMC Canyon

• 2006-2010 Hummer H3

• 2009-2010 Hummer H3T

PROGRAMMING INSTRUCTIONS

IMPORTANT: ALL TRANSMITTERS WHICH ARE TO BE RECOGNIZED BY THE

REMOTE CONTROL DOOR LOCK RECEIVER (RCDLR) MUST BE PROGRAMMED IN A

SINGLE PROGRAMMING SEQUENCE. IF THE SYSTEM IS PLACED IN PROGRAM MODE IT

WILL ERASE ALL PREVIOUSLY PROGRAMMED TRANSMITTERS UPON THE RECEIPT OF

THE PROGRAMMING SIGNAL FROM THE FIRST TRANSMITTER. UP TO FOUR TRANSMIT-

TERS CAN BE PROGRAMMED. TO PREVENT THE PROGRAMMING OF TRANSMITTERS TO

AN INCORRECT VEHICLE, DO NOT OPERATE OR PROGRAM THE TRANSMITTERS IN THE

VICINITY OF OTHER VEHICLES THAT ARE IN THE KEYLESS ENTRY PROGRAM MODE.

1. Remove the ignition key from the ignition lock cylinder.

2. Remove the body control module (BCM) PRGRM fuse from the fuse

block. (Refer to “Instrument Panel Fuse Block” in your Owner’s

Manual for the location of your fuse block and the Fuse Usage Chart.)

3. Close all of the doors.

4. Insert the ignition key into the ignition lock cylinder.

5. Turn the ignition to ACC.

6. Turn the ignition to OFF, and then back to ACC within 1 second.

7. Open and then close any vehicle door. The vehicle will chime in

order to confirm that the programming mode has been entered.

8. Press and hold the transmitter LOCK and UNLOCK buttons simul-

taneously for approximately 14 seconds.

IMPORTANT: AFTER APPROXIMATELY 3–5 SECONDS THE VEHICLE WILL CHIME

ONCE TO CONFIRM THAT THE PROGRAMMING HAS BEEN COMPLETED FOR THAT

TRANSMITTER.

9. Repeat the previous step in order to program each additional trans-

mitter.

10. Remove the ignition key from the ignition lock cylinder.

11. Install the BCM PRGRM fuse into the fuse block.

12. Operate the functions of each transmitter in order to verify correct

system operation.

Product specificaties